HS-405 Modification
My first mistake... after the anxiety left I found
a solution (the anxiety lasted for about 4 hours). I made the mistake of
drilling HS-810 and HS-814 for the HS-405 rib attachment, my problem was
that after drilling the holes through into HS-405 I found that I did not
have edge tolerance for the -4 rivet. After seeing I had some room in the
HS-602 front spar I fabricated new flanges for the HS-405 which were just
long enough to give me edge tolerance. A quick call to Vans and they seemed
to like my fix.
This page last updated on 11/16/99 3:36:05 PM.
